Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM › from 2020.09
RM36W0E _57 Power Source / Network _088060 NETWORKING _0420500 LIN COMMUNICATION SYSTEM C

NETWORKING  LIN COMMUNICATION SYSTEM  B276C88  Alarm / Wiper LIN Bus off  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
B276C88 Alarm / Wiper LIN Bus off No communication between main body ECU (multiplex network body ECU), rain sensor and map light sub-assembly for 10 seconds or more.
·

Main body ECU (multiplex network body ECU)

·

Theft warning ultrasonic sensor

·

Rain sensor

·

Harness or connector



WIRING DIAGRAM

C449242E02
1.563,0.948 2.177,1.146 0.615,0.198 10 false LIN4 5.292,0.948 5.906,1.146 0.615,0.198 10 false LIN1 0.406,1.667 2.052,2.042 1.646,0.375 10 false Main Body ECU (Multiplex Network Body ECU) 5.24,1.656 6.771,2.094 1.531,0.438 10 false Theft Warning Ultrasonic Sensor 5.302,2.792 5.76,2.99 0.458,0.198 10 false MPX 5.281,3.51 6.969,3.708 1.688,0.198 10 false Rain Sensor 0.74,4.333 4.406,4.531 3.667,0.198 10 false : LIN Communication Line 2,0.781 2.313,0.979 0.313,0.198 10 false 11 5.042,0.792 5.354,0.99 0.313,0.198 10 false 2 5.052,2.635 5.365,2.833 0.313,0.198 10 false 3 0.406,1.49 0.719,1.688 0.313,0.198 10 false H5 5.24,1.49 5.604,1.688 0.365,0.198 10 false V14 5.281,3.333 5.646,3.531 0.365,0.198 10 false V9

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.


PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Main Body > Clear DTCs
50002 449

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Main Body > Trouble Codes
50001 449

Result:
Result Proceed to
DTC B276C88 is output A
DTC B276C88 is not output B



A

3.CHECK THEFT WARNING ULTRASONIC SENSOR

B

3.CHECK THEFT WARNING ULTRASONIC SENSOR
a.

Disconnect the V14 theft warning ultrasonic sensor connector.


b.

Check if the DTC is output.

Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 449

Result:
Result Proceed to
DTC B276C88 is output A
DTC B276F87 is output B



A

4.CHECK RAIN SENSOR

B

REPLACE THEFT WARNING ULTRASONIC SENSOR

4.CHECK RAIN SENSOR
a.

Disconnect the V9 rain sensor connector.


b.

Check if the DTC is output.

Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>TERMINALS OF ECU

Body Electrical > Main Body > Trouble Codes
50001 449

Result:
Result Proceed to
DTC B276C88 is output A
DTC B127987 is output B



A

5.CHECK HARNESS AND CONNECTOR (LIN BUS CIRCUIT)

B

5.CHECK HARNESS AND CONNECTOR (LIN BUS CIRCUIT)
a.

Reconnect the H5 main body ECU (multiplex network body ECU) connector.


b.

Disconnect the V14 theft warning ultrasonic sensor connector.


c.

Disconnect the V9 rain sensor connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H5-11 (LIN4) - Body ground Always 10 kΩ or higher
H5-11 (LIN4) - Other terminals Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR