Home › Vehicle Interior › SEAT › FRONT SEATBACK HEATER (for 3 Door) › from 2020.09
RM36W0E _58 Vehicle Interior _088297 SEAT _0452482 FRONT SEATBACK HEATER(for 3 Door) A

SEAT  FRONT SEATBACK HEATER(for 3 Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Effect/Inoperative Function When Necessary Procedures are not Performed Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Effect/Inoperative Function When Necessary Procedures are not Performed Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



CAUTION:
·
B401522

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the driver side and front passenger side.

·

The procedure listed below is for the driver side.



PROCEDURE

Hide 73240 1.REMOVE FRONT SEAT INNER BELT ASSEMBLY

Hide 72495 2.REMOVE FRONT SEAT VERTICAL ADJUSTER HANDLE (for Driver Side)

Hide 72551 3.REMOVE NO.1 RECLINING HINGE COVER

Hide 72526 4.REMOVE RECLINING ADJUSTER RELEASE HANDLE

Hide 71849 5.REMOVE SEAT ADJUSTER COVER CAP (for Driver Side)

Hide 71812D 6.REMOVE FRONT SEAT CUSHION SHIELD

Hide 71862 7.REMOVE FRONT SEAT INNER CUSHION SHIELD

Hide 8.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71739A 9.REMOVE FRONT SEATBACK BEZEL (for Sports Seat Type)

Hide 71930A 10.REMOVE FRONT SEAT HEADREST SUPPORT ASSEMBLY

Hide 11.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Hide 71074S 12.REMOVE SEPARATE TYPE FRONT SEATBACK COVER

Hide 87510N 13.REMOVE FRONT SEATBACK HEATER ASSEMBLY

a.
B602097

for Sporty Seat Type:

i.

Remove the 14 tag pins and front seatback heater assembly from the separate type front seatback cover.



b.
B602098

for Sports Seat Type:

i.

Remove the 14 tag pins and front seatback heater assembly from the separate type front seatback cover.