The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat airbag assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
73240
1.REMOVE FRONT SEAT INNER BELT ASSEMBLY
72494A
2.REMOVE FRONT SEAT VERTICAL ADJUSTER HANDLE (for Driver Side)
72551
3.REMOVE NO.1 RECLINING HINGE COVER
72526
4.REMOVE RECLINING ADJUSTER RELEASE HANDLE
71849
5.REMOVE SEAT ADJUSTER COVER CAP (for Driver Side)
71812D
6.REMOVE FRONT SEAT CUSHION SHIELD
71862
7.REMOVE FRONT SEAT INNER CUSHION SHIELD
8.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
9.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
71072S
10.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
87510L
11.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY
for Sporty Seat Type:
Remove the 19 tag pins and front seat cushion heater assembly from the separate type front seat cushion cover.
for Sports Seat Type:
Remove the 14 tag pins and front seat cushion heater assembly from the separate type front seat cushion cover.