Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY (for 5 Door) › from 2020.09
RM36W0E _58 Vehicle Interior _088020 SUPPLEMENTAL RESTRAINT SYSTEMS _0452650 CURTAIN SHIELD AIRBAG ASSEMBLY(for 5 Door) A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY(for 5 Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 62170A 1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

NOTICE:

When installing a curtain shield airbag assembly, have assistants hold it to prevent it from bending.


a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Do not begin this procedure within 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.

Engage the hooks and claws to temporarily install the curtain shield airbag assembly.

B583373


d.

Install the 4 new bolts.

B583374C01
3.698,2.323 4.031,2.323 true 4.917,0.698 5.156,0.531 true 2.188,0.49 1.958,0.292 true 3.76,0.5 3.531,0.302 true 4.073,2.229 4.385,2.427 0.313,0.198 10 false *a 5.177,0.417 5.385,0.594 0.208,0.177 10 true *1 1.729,0.177 1.938,0.354 0.208,0.177 10 true *1 3.313,0.167 3.521,0.344 0.208,0.177 10 true *2
*1 Clip *2 Roof Side Inner Garnish Clip
*a Pin - -
V113147

Install in this Direction - -


Torque:
14 N*m (143 kgf*cm, 10 ft.*lbf)

NOTICE:

Do not twist the curtain shield airbag assembly when installing it.



e.

Install the curtain shield airbag assembly with a new roof side inner garnish clip and new clips as shown in the illustration.

HINT:

Engage the claws to install each new clip.



f.

Using needle nose pliers, push the pins into the clips.

NOTICE:
·

Do not damage the pins.

·

Make sure that the pins of the clips are pushed in firmly.




g.

Connect the airbag connector.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 4. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART