The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat airbag assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
73230
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY
72495
3.REMOVE FRONT SEAT VERTICAL ADJUSTER HANDLE (for Driver Side)
72551
4.REMOVE NO.1 RECLINING HINGE COVER
72526
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE
71849
6.REMOVE SEAT ADJUSTER COVER CAP (for Driver Side)
71812D
7.REMOVE FRONT SEAT CUSHION SHIELD
71862
8.REMOVE FRONT SEAT INNER CUSHION SHIELD
9.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
71739A
10.REMOVE FRONT SEATBACK BEZEL (for Sports Seat Type)
71930A
11.REMOVE FRONT SEAT HEADREST SUPPORT ASSEMBLY
12.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
73920A
13.REMOVE FRONT SEAT AIRBAG ASSEMBLY
|
Deployment Side |
When storing the front seat airbag assembly, keep the airbag deployment side facing upward.
If the airbag deploys for any reason, it may cause a serious accident.
Disengage the clamp.
Remove the 2 nuts and front seat airbag assembly.
Do not reuse the nut.
If the installation surface or surrounding area of the front seat airbag assembly is deformed or damaged, replace the front seatback frame sub-assembly with a new one.