Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › 2020.03–2020.07
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0425342 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  C051262  Right Rear Wheel Speed Sensor Signal Compare Failure  


DESCRIPTION

Refer to DTC C05121F.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>C05121F

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C051262 Right Rear Wheel Speed Sensor Signal Compare Failure Any of the following is detected:
·

A lowest wheel speed is 10 km/h (6 mph) or more, the difference between the highest and lowest wheel speeds is 2 km/h (1 mph) or less, and the rotation direction of any one of the wheels is not detected for 15 seconds or more.

·

A vehicle speed is 30 km/h (19 mph) or more and the rotation direction of one of the wheels is different from those of other 3 wheels as well as it is not detected for 1 second or more.


Rear speed sensor RH (rear axle hub and bearing assembly RH) Brake

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>TEST MODE PROCEDURE

·

After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>TEST MODE PROCEDURE



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Chassis > Brake > Clear DTCs
50002 435

b.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Check the DTCs that are output.

Chassis > Brake > Trouble Codes
50001 435

Result:
Result Proceed to
Only C051262 is output A
None of the above conditions are met B



A

3.REPLACE REAR AXLE HUB AND BEARING ASSEMBLY RH

B

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

3.REPLACE REAR AXLE HUB AND BEARING ASSEMBLY RH
HINT:

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>REMOVAL


Result:
Proceed to
NEXT



NEXT

END