Check that the following "Wi-Fi" connection setting conditions are met.
"Wi-Fi" connection setting is turned on
Communication setting is set to "Wi-Fi"
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the conditions and procedure for establishing a "Wi-Fi" connection, and perform "Wi-Fi" connection again.
As there may be wave interference, disconnect other "Wi-Fi" compatible devices or "Bluetooth" compatible devices before establishing a "Wi-Fi" connection.
A "Wi-Fi" connection can be established manually or automatically.
There are 3 ways to establish a manual connection: Connecting using simple setting, connecting by searching for a "Wi-Fi" access point and inputting a password, and connecting by inputting an SSID and password.
Even though an automatic connection is enabled, a connection can be established only when a "Wi-Fi" access point with the same SSID and password that were used for a previous connection exists.
It may not be possible to establish a "Wi-Fi" connection in a region other than the region where the vehicle was purchased.
| Result | Proceed to |
|---|---|
| "Wi-Fi" connection can be established. | A |
| "Wi-Fi" connection cannot be established. | B |
A
B
Bring a portable device to be used to establish a "Wi-Fi" connection into the cabin and perform "Wi-Fi" connection again near the in-vehicle device.
Considering the radio wave environment around the vehicle, move the vehicle and establish a "Wi-Fi" connection.
Depending on the portable device, operation by the customer (Internet sharing, tethering settings, etc.) may be required each time a "Wi-Fi" connection is established.
| Result | Proceed to |
|---|---|
| "Wi-Fi" connection can be established. | A |
| "Wi-Fi" connection cannot be established. | B |
A
B
Check the condition of portable device.
The head unit may not be able to connect to the access point due to the condition of the portable device (e.g., the power may not be turned on, tethering may be turned off, or the SSID (name of access point) may not be sent).
When the power of the portable device is turned off, tethering may be turned off.
| Result | Proceed to |
|---|---|
| The power is off or tethering is turned off (access point). | A |
| Other than above. | B |
A
B
Check if the "Wi-Fi" access point is discovered on a manual search.
| Result | Proceed to |
|---|---|
| There are no search results and SSID is not sent (access point). | A |
| The device is detected via a network search. | B |
A
B
Change the location to another place and perform "Wi-Fi" connection.
Bring the portable device close to the display of the system device.
| Result | Proceed to |
|---|---|
| "Wi-Fi" connection can be established. | A |
| Function cannot be stabilized. | B |
| Even though setting is performed, "Wi-Fi" connection cannot be established. | C |
A
B
C