| Code | Tester Display | Measurement Item | Trouble Area | RoB Output from |
|---|---|---|---|---|
| X20D8 | Zero Point Calibration of Steering Angle Sensor Not Acquired | History of being unable to obtain the steering angle zero point | ·
Sensor installation ·
Yaw rate and acceleration sensor (airbag sensor assembly) |
Brake |
This Vehicle Control History (RoB) may be output during situations when the steering angle sensor zero point calibration temporarily cannot be acquired, such as when the stop light is stuck ON.
If the yaw rate and acceleration sensor (airbag sensor assembly) was replaced or reinstalled, perform "Calibration".
Using the GTS, perform the Health Check.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Check that the airbag sensor assembly has been installed properly.
The sensor should be tightened to the specified torque.
The sensor is not installed in a tilted position.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.
When driving at a speed of 15 km/h or more for 1 second or more, the slip indicator light turns off.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, clear the Vehicle Control History (RoB).
| Tester Display |
|---|
| Vehicle Control History (RoB) |
| Proceed to |
|---|
| NEXT |
NEXT
Perform a road test under the same malfunction conditions recreated based on the Freeze Frame Data or customer problem analysis.
Using the GTS, check for Vehicle Control History (RoB).
| Tester Display |
|---|
| Vehicle Control History (RoB) |
| Result | Proceed to |
|---|---|
| X20D8 is not output | A |
| X20D8 is output | B |
A
B
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION
| Proceed to |
|---|
| NEXT |
NEXT