The stereo component equalizer assembly sends a mute signal to the radio and display receiver assembly. The radio and display receiver assembly controls the volume according to the mute signal from the stereo component equalizer assembly.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Remove the stereo component equalizer assembly with the connector(s) still connected.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ACTIVE NOISE CONTROL ECU>REMOVAL
| *a | Component with harness connected
(Stereo Component Equalizer Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O131-19 (TMU1) - Body ground | Ignition switch ACC, audio system playing
→ Emergency call mode |
2.0 V or higher
→ Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H80 radio and display receiver assembly connector.
Disconnect the O131 stereo component equalizer assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H80-3 (TMUT) - O131-19 (TMU1) | Always | Below 1 Ω |
| H80-3 (TMUT) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the O131 stereo component equalizer assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O131-19 (TMU1) - Body ground | Ignition switch ACC | 2.0 V or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG