Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB (for TMMF, TMMCZ Made) › from 2021.11
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0491615 FRONT AXLE HUB(for TMMF, TMMCZ Made) G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB(for TMMF, TMMCZ Made)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

The following procedure is for the LH side.

·

Use the same procedure for the RH side and LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 4.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C427803

Using a dial indicator with magnetic base, check for looseness near the center of the front axle hub sub-assembly.

Maximum Looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.



HINT:

If the looseness exceeds the maximum, replace the front axle hub sub-assembly.



Hide 5.INSPECT FRONT AXLE HUB RUNOUT

a.
C427804

Using a dial indicator with magnetic base, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts.

Maximum Runout:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the front axle hub bolts.

·

Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor.



HINT:

If the runout exceeds the maximum, replace the front axle hub sub-assembly.



Hide 8.INSTALL FRONT WHEEL