Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM (for TMMF, TMMCZ Made RH Side) › from 2021.11
RM36W0E _53 Suspension _087263 FRONT SUSPENSION _0491950 FRONT LOWER SUSPENSION ARM(for TMMF, TMMCZ Made RH Side) A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM(for TMMF, TMMCZ Made RH Side)  INSTALLATION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 48068 1.TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

a.
C437617

Temporarily install the front lower No. 1 suspension arm sub-assembly RH to the front suspension crossmember sub-assembly with the 2 bolts and nut.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.



Hide 51201 2.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 48068 3.FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

a.
C436133C01
1.333,2.208 1.646,2.406 0.313,0.198 10 false *a 1.156,0.292 1.323,0.49 0.167,0.198 10 true A 2.208,1.344 2.375,1.542 0.167,0.198 10 true B
*a Torque Wrench Fulcrum Length


Using SST, fully tighten the bolt (A).

SST
09729-00220  

Torque:
Specified tightening torque : 147 N*m (1499 kgf*cm, 108 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 200 mm (7.87 in.)) + torque wrench (fulcrum length of 255 mm (10.04 in.)): 82.4 N*m (840 kgf*cm, 61 ft.*lbf)




b.

Fully tighten the bolt (B).

Torque:
125 N*m (1275 kgf*cm, 92 ft.*lbf)

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.



Hide 51447D 4.INSTALL CENTER NO. 4 ENGINE UNDER COVER

Hide 51441C 6.INSTALL ENGINE UNDER COVER RH

HINT:

Perform the same procedure as for the LH side.


Hide 51451A 7.INSTALL CENTER ENGINE UNDER COVER

Hide 8.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Hide 9.PERFORM INITIALIZATION

Parking support brake system (Click here)
Parking assist monitor system (Click here)