Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF, TMMCZ Made) › from 2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0494155 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF, TMMCZ Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF, TMMCZ Made)  C13C01C  Brake Pressure Control Solenoid "A" Control Circuit Voltage Out of Range  C13C049  Brake Pressure Control Solenoid "A" Control Internal Electronic Failure  C13C91C  Brake Pressure Control Solenoid "B" Control Circuit Voltage Out of Range  C13C949  Brake Pressure Control Solenoid "B" Control Internal Electronic Failure  


DESCRIPTION

The ABS solenoid relay and master cylinder cut solenoid valves are built into the brake actuator assembly.

Depending on the operating conditions, the master cylinder cut solenoid valves regulate the brake fluid pressure generated by the pump motor.

When these DTCs are stored, the fail-safe function operates and the ABS solenoid relay is turned off to prevent the master cylinder cut solenoid valves from operating.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C13C01C Brake Pressure Control Solenoid "A" Control Circuit Voltage Out of Range
·

A current leak in the master cylinder cut solenoid circuit is detected during the self test.

·

The master cylinder cut solenoid valve operation request signal and master cylinder cut solenoid valve operation feedback signal do not match for a certain period of time.


Skid control ECU (brake actuator assembly) Brake
C13C049 Brake Pressure Control Solenoid "A" Control Internal Electronic Failure An internal malfunction in the master cylinder cut solenoid circuit is detected during the self test. Skid control ECU (brake actuator assembly) Brake
C13C91C Brake Pressure Control Solenoid "B" Control Circuit Voltage Out of Range
·

A current leak in the master cylinder cut solenoid circuit is detected during the self test.

·

The master cylinder cut solenoid valve operation request signal and master cylinder cut solenoid valve operation feedback signal do not match for a certain period of time.


Skid control ECU (brake actuator assembly) Brake
C13C949 Brake Pressure Control Solenoid "B" Control Internal Electronic Failure An internal malfunction in the master cylinder cut solenoid circuit is detected during the self test. Skid control ECU (brake actuator assembly) Brake

CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake actuator assembly), perform yaw rate and acceleration sensor zero point calibration and store system information memorization.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF, TMMCZ Made)>UTILITY


PROCEDURE

1.CHECK VEHICLE TYPE
a.

Check the vehicle specification.


Result:
Result Proceed to
LHD A
RHD B



A

B