When the vehicle information is not registered to the skid control ECU (brake actuator assembly), the following DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U030051 | Internal Control Module Software Incompatibility Not Programmed | Vehicle information registration has not been performed. | ·
CAN communication system ·
Skid control ECU (brake actuator assembly) |
Brake |
Operate the GTS, and check for DTCs related to the CAN communication system.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| Any CAN communication system relating DTCs are output | A |
| None of the above conditions are met | B |
A
B
Operate the GTS to perform Health Check.
Check DTCs.
DTCs indicating a vehicle information mismatch with the skid control ECU (brake actuator assembly) are not output by any ECU.
Turn the ignition switch off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the zero point calibration data and system information.
| Tester Display |
|---|
| Reset Memory |
| Proceed to |
|---|
| NEXT |
NEXT
Operate the GTS to perform "Calibration" and store system information memorization.
| Tester Display |
|---|
| Calibration |
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
None
Procedure1
Operate the GTS to clear the codes.
Post-procedure1
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Operate the GTS to read the DTCs.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| U030051 is not output | A |
| U030051 is output | B |
A
B
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model TMMF, TMMCZ Made LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model TMMF Made RHD)>REMOVAL