Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF, TMMCZ Made) › from 2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0494155 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF, TMMCZ Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF, TMMCZ Made)  U030057  Internal Control Module Software Incompatibility Invalid / Incompatible Software Component  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives the vehicle information from the ECUs and sensors via CAN communication.

DTC U030057 is stored when the vehicle information received and that stored in the skid control ECU (brake actuator assembly) do not match.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U030057 Internal Control Module Software Incompatibility Invalid / Incompatible Software Component
·

The vehicle information received via the CAN communication system and the vehicle information stored in the skid control ECU do not match.

·

The vehicle information received via the CAN communication system is invalid.


·

CAN communication system

·

Skid control ECU (brake actuator assembly)


Brake

PROCEDURE

1.CHECK DTC OF OTHER COMPONENTS (CAN COMMUNICATION SYSTEM)
a.

Operate the GTS, and check for DTCs related to the CAN communication system.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM

Result:
Result Proceed to
Any CAN communication system relating DTCs are output A
None of the above conditions are met B




A

B

2.CHECK DTC (HEALTH CHECK)
2.CHECK DTC (HEALTH CHECK)
a.

Operate the GTS to perform Health Check.


b.

Check DTCs.

OK:

DTCs indicating a vehicle information mismatch with the skid control ECU (brake actuator assembly) are not output by any ECU.



c.

Turn the ignition switch to off.


Result:
Proceed to
OK
NG



OK

3.CHECK PART NUMBER (BRAKE ACTUATOR ASSEMBLY)

NG

3.CHECK PART NUMBER (BRAKE ACTUATOR ASSEMBLY)
a.

Check that the proper skid control ECU (brake actuator assembly) is installed.

OK:

Proper skid control ECU (brake actuator assembly) is installed.



Result:
Proceed to
OK
NG



OK

4.CLEAR SYSTEM INFORMATION DATA

NG

4.CLEAR SYSTEM INFORMATION DATA
a.

Clear the zero point calibration data and system information.

Chassis > Brake > Utility
Tester Display
Reset Memory
50005 435 4560
Result:
Proceed to
NEXT




NEXT

5.PERFORM ZERO POINT CALIBRATION
5.PERFORM ZERO POINT CALIBRATION
a.

Operate the GTS to perform "Calibration" and store system information memorization.

Chassis > Brake > Utility
Tester Display
Calibration
50005 435 4554
Result:
Proceed to
NEXT




NEXT

6.CLEAR DTC
6.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

b.

Operate the GTS to clear the codes.

Chassis > Brake > Clear DTCs
50002 435

Post-procedure1

c.

Turn the ignition switch off.


Result:
Proceed to
NEXT



NEXT

7.RECONFIRM DTC
7.RECONFIRM DTC
a.

Operate the GTS to read the DTCs.

Chassis > Brake > Trouble Codes
50001 435

b.

Check if the same DTC is output.


Result:
Result Proceed to
U030057 is not output A
U030057 is output B



A

END

B