2005-2008 Yaris · Service Manual BRAKE

TERMINALS OF ECU

System information · Vehicles built from Aug 2005


Terminals of ECU
C110610E01
Skid Control ECU: 
Symbols (Terminals No.)
Terminal Description
GND2 (A31-1)
Skid control ECU ground
BM (A31-2)
Motor relay input
FR+ (A31-3)
Front RH wheel speed sensor power supply
FL- (A31-4)
Front LH wheel speed signal input
RR+ (A31-5)
Rear RH wheel speed signal power supply
RL- (A31-6)
Rear LH wheel speed signal input
CANH (A31-11)
CAN communication line H
SP1 (A31-12)
Speed signal output for combination meter
MRF (A31-14)
Fail safe motor relay output
MR (A31-15)
Motor relay output
FR- (A31-17)
Front RH wheel speed signal input
FL+ (A31-18)
Front LH wheel speed sensor power supply
RR- (A31-19)
Rear RH wheel speed signal input
RL+ (A31-20)
Rear LH wheel speed sensor power supply
CANL (A31-25)
CAN communication line L
STP (A31-27)
Stop light switch input
+BS (A31-31)
Solenoid valve power supply
GND1 (A31-32)
Skid control ECU ground
WFSE (A31-42)
WFSE input
R+ (A31-45)
Power supply for motor relay
IG1 (A31-46)
ECU power supply
E114510E04
Main Body ECU: 
Symbols (Terminals No.)
Terminal Description
PKB (4C-2)
Parking brake switch input

Terminal inspection

  1. Disconnect the connector and measure the resistance and voltage on the wire harness side.

    HINT:
    The voltage cannot be measured with the connector connected to the skid control ECU as the connector is water resistant.

    F049377E03
    Skid Control ECU: 
    Symbols
    Wiring Color
    Terminal Description
    Conditions
    Specified Conditions
    GND2 (A31-1) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    STP (A31-27) - Body ground
    G - Body ground
    Stop light switch input
    Stop light switch OFF
    Brake pedal released
    Below 1.5 V
    STP (A31-27) - Body ground
    G - Body ground
    Stop light switch input
    Stop light switch ON
    Brake pedal depressed
    8 to 16 V
    +BS (A31-31) - Body ground
    W - Body ground
    Solenoid relay power supply
    Always
    11 to 14 V
    IG1 (A31-46) - Body ground
    B - Body ground
    ECU power supply
    Ignition switch on (IG)
    11 to 14 V
    C118700E01
    Main Body ECU: 
    Symbols
    Wiring Color
    Terminal Description
    Conditions
    Specified Conditions
    PKB (4C-2) - Body ground
    Y - Body ground
    Parking brake switch input
    Parking brake switch ON
    Below 1 Ω
    PKB (4C-2) - Body ground
    Y - Body ground
    Parking brake switch input
    Parking brake switch OFF
    10 kΩ or higher

← PROBLEM SYMPTOMS TABLE (from Aug 2005)DIAGNOSIS SYSTEM (from Aug 2005) →