PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built from Aug 2005
| Symptom |
Suspected area |
See page |
| ABS, BA and/or EBD does not operate |
1. Check for DTCs again and make sure that normal system code displayed |
Click here
|
| 2. IG power source circuit |
Click here
|
|
| 3. Front speed sensor circuit |
Click here
|
|
| 4. Skid control sensor circuit |
Click here
|
|
| 5. Check ABS and TRACTION actuator using intelligent tester (Check ABS and TRACTION actuator operation using active test function) If abnormal, check hydraulic circuit for leakage |
Click here
|
|
| 6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| ABS, BA and/or EBD does not operate efficiently |
1. Check for DTCs again and make sure that normal system code displayed |
Click here
|
| 2. Front speed sensor circuit |
Click here
|
|
| 3. Skid control sensor circuit |
Click here
|
|
| 4. Stop light switch circuit |
Click here
|
|
| 5. Check ABS and TRACTION actuator using intelligent tester (Check ABS and TRACTION actuator operation using active test function) If abnormal, check hydraulic circuit for leakage |
Click here
|
|
| 6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| VSC and/or TRC does not operate |
1. Check for DTCs again and make sure that normal system code displayed |
Click here
|
| 2. IG power source circuit |
Click here
|
|
| 3. Check hydraulic circuit for leakage |
- |
|
| 4. Front speed sensor circuit |
Click here
|
|
| 5. Skid control sensor circuit |
Click here
|
|
| 6. Yaw rate sensor circuit |
Click here
|
|
| 7. Steering angle sensor circuit |
Click here
|
|
| 8. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| Sensor signal check cannot be performed |
1. TS and CG terminal circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| DTC check cannot be performed |
1. Check for DTCs again and make sure that normal system code displayed |
Click here
|
| 2. TC and CG terminal circuit |
Click here
|
|
| 3. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| ABS warning light remains on |
1. ABS warning light circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| ABS warning light does not come on |
1. ABS warning light circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| VSC warning light remains on |
1. VSC warning light circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| VSC warning light does not come on |
1. VSC warning light circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| BRAKE warning light remains on |
1. BRAKE warning light circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| BRAKE warning light does not come on |
1. BRAKE warning light circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| SLIP indicator light remains on |
1. SLIP indicator light circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| SLIP indicator light does not come on |
1. SLIP indicator light circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|
|
| Skid control buzzer abnormal |
1. Skid control buzzer circuit |
Click here
|
| 2. ABS and TRACTION actuator (skid control ECU) |
Click here
|