2005-2008 Yaris · Service Manual BRAKE

TERMINALS OF ECU

System information · Vehicles built from Nov 2005


Terminals of ECU
C129337E01
Skid Control ECU: 
Symbols (Terminals No.)
Terminal Description
BM (A39-1)
Motor relay input
STP (A39-4)
Stop light switch input
SS1 (A39-6)
CAN communication line High with yaw rate sensor
IG1 (A39-7)
ECU power supply
CANL (A39-8)
CAN communication line Low
CANH (A39-10)
CAN communication line High
SP1 (A39-11)
Speed signal output for combination meter
SS2 (A39-12)
CAN communication line Low with yaw rate sensor
GND1 (A39-13)
Skid control ECU ground
+BS (A39-14)
Solenoid relay power supply
RL- (A39-15)
Rear LH wheel speed signal input
RL+ (A39-16)
Rear LH wheel speed sensor power supply
VYS (A39-17)
Yaw rate sensor power supply
FR+ (A39-18)
Front RH wheel speed sensor power supply
FR- (A39-19)
Front RH wheel speed signal input
LVL2 (A39-20)
Brake fluid level warning switch input
FL- (A39-21)
Front LH wheel speed signal input
FL+ (A39-22)
Front LH wheel speed sensor power supply
GYAW (A39-23)
Yaw rate sensor ground
RR+ (A39-24)
Rear RH wheel speed sensor power supply
RR- (A39-25)
Rear RH wheel speed signal input
GND2 (A39-26)
Pump motor ground
E114510E04
Main Body ECU: 
Symbols (Terminals No.)
Terminal Description
PKB (4C-2)
Parking brake switch input

Terminal inspection

  1. Disconnect the connector and measure the resistance and voltage on the wire harness side.

    HINT:
    The voltage cannot be measured with the connector connected to the skid control ECU as the connector is water resistant.

    C129338E01
    Skid Control ECU: 
    Symbols
    Wiring Color
    Terminal Description
    Conditions
    Specified Conditions
    BM (A39-1) - Body ground
    B - Body ground
    Motor relay input
    Always
    Below 1 Ω
    STP (A39-4) - Body ground
    Y - Body ground
    Stop light switch input
    Stop light switch OFF
    Brake pedal released
    Below 1.5 V
    STP (A39-4) - Body ground
    Y - Body ground
    Stop light switch input
    Stop light switch ON
    Brake pedal depressed
    8 to 16 V
    IG1 (A39-7) - Body ground
    P - Body ground
    ECU power supply
    Ignition switch on (IG)
    10 to 14 V
    GND1 (A39-13) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Skid control ECU ground
    Below 1 Ω
    +BS (A39-14) - Body ground
    W - Body ground
    Solenoid relay power supply
    Always
    10 to 14 V
    VYS (A39-17) - Body ground
    O - Body ground
    Yaw rate sensor power supply
    Always
    10 to 14 V
    GYAW (A39-23) - Body ground
    L - Body ground
    Yaw rate sensor ground
    Always
    Below 1 Ω
    GND2 (A39-26) - Body ground
    W-B - Body ground
    Pump motor ground
    Always
    Below 1 Ω
    C118700E01
    Main Body ECU: 
    Symbols
    Wiring Color
    Terminal Description
    Conditions
    Specified Conditions
    PKB (4C-2) - Body ground
    Y - Body ground
    Parking brake switch input
    Parking brake switch ON
    Below 1 Ω
    PKB (4C-2) - Body ground
    Y - Body ground
    Parking brake switch input
    Parking brake switch OFF
    10 kΩ or higher

← PROBLEM SYMPTOMS TABLE (from Nov 2005)DIAGNOSIS SYSTEM (from Nov 2005) →