TERMINALS OF ECU
System information · Vehicles built from Nov 2005
| Terminals of ECU |


| Symbols (Terminals No.) |
Terminal Description |
| BM (A39-1) |
Motor relay input |
| STP (A39-4) |
Stop light switch input |
| IG1 (A39-7) |
ECU power supply |
| CANL (A39-8) |
CAN communication line L |
| CANH (A39-10) |
CAN communication line H |
| SP1 (A39-11) |
Speed signal output for combination meter |
| GND1 (A39-13) |
Skid control ECU ground |
| +BS (A39-14) |
Solenoid relay power supply |
| RL- (A39-15) |
Rear LH wheel speed signal input |
| RL+ (A39-16) |
Rear LH wheel speed sensor power supply |
| FR+ (A39-18) |
Front RH wheel speed sensor power supply |
| FR- (A39-19) |
Front RH wheel speed signal input |
| LVL2 (A39-20) |
Brake fluid level warning switch input |
| FL- (A39-21) |
Front LH wheel speed signal input |
| FL+ (A39-22) |
Front LH wheel speed sensor power supply |
| RR+ (A39-24) |
Rear RH wheel speed sensor power supply |
| RR- (A39-25) |
Rear RH wheel speed signal input |
| GND2 (A39-26) |
Pump motor ground |


| Symbols (Terminals No.) |
Terminal Description |
| PKB (4C-2) |
Parking brake switch input |
| Terminal inspection |
Disconnect the connector and measure the resistance and voltage on the wire harness side.
- HINT:
- The voltage cannot be measured with the connector connected to the skid control ECU as the connector is water resistant.


Skid Control ECU: Symbols
Wiring Color
Terminal Description
Conditions
Specified Conditions
BM (A39-1) - Body ground
B - Body ground
Motor relay input
Always
Below 1 Ω
STP (A39-4) - Body ground
Y - Body ground
Stop light switch input
Stop light switch OFF
Brake pedal released
Below 1.5 V
STP (A39-4) - Body ground
Y - Body ground
Stop light switch input
Stop light switch ON
Brake pedal depressed
10 to 14 V
IG1 (A39-7) - Body ground
P - Body ground
ECU power supply
Ignition switch on (IG)
10 to 14 V
GND1 (A39-13) - Body ground
W-B - Body ground
Skid control ECU ground
Skid control ECU ground
Below 1 Ω
+BS (A39-14) - Body ground
W - Body ground
Solenoid relay power supply
Always
10 to 14 V
GND2 (A39-26) - Body ground
W-B - Body ground
Pump motor ground
Always
Below 1 Ω


Main Body ECU: Symbols
Wiring Color
Terminal Description
Conditions
Specified Conditions
PKB (4C-2) - Body ground
Y - Body ground
Parking brake switch input
Parking brake switch ON
Below 1 Ω
PKB (4C-2) - Body ground
Y - Body ground
Parking brake switch input
Parking brake switch OFF
10 kΩ or higher