DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Nov 2005
| DIAGNOSIS |
The table below indicates which lights come on when there are malfunctions in particular functions.
○: Light ON, -: Light OFF
![]() ![]() |
| Item / Trouble Area |
ABS System |
EBD System |
Skid Control ECU |
| ABS warning light |
○ |
○ |
○ |
| BRAKE warning light |
- |
○ |
○ |
- HINT:
- The DTCs can be read by connecting SST (09843-18040) between the TC and CG terminals of the DLC3 and observing the blinking pattern of the ABS warning light, or by using an intelligent tester (Click here).
- This system has a sensor signal check function (Click here).
- The DTCs can be read by connecting SST (09843-18040) between the TC and CG terminals of the DLC3 and observing the blinking pattern of the ABS warning light, or by using an intelligent tester (Click here).
| WARNING LIGHT CHECK |
Release the parking brake lever.
- NOTICE:
- Before releasing the parking brake lever, set chocks to hold the vehicle for safety.
- HINT:
- When the parking brake is applied or the brake fluid level is low, the BRAKE warning light comes on.
When the ignition switch is turned on (IG), check that the ABS warning light and BRAKE warning light come on and go off in about 3 seconds.
- HINT:
- If the warning lights do not illuminate, confirm whether the bulbs have burned out, and also check for CAN communication system DTC, since the skid control ECU and combination meter are connected by CAN communication line.
- If the warning light remains on, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are instructed in the sections listed in the table below.
Section Title
See Page
ABS Warning Light Remains ON
Click here
BRAKE Warning Light Remains ON
Click here

