DTC CHECK / CLEAR
Troubleshooting · Vehicles built from Aug 2005
| DTC CHECK (USING INTELLIGENT TESTER) |
Check DTCs.
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Turn the tester on.
Read the DTCs using the intelligent tester.
Select the following menu items: Chassis / ABS/VSC/TRC/ DTC.
| DTC CLEAR (USING INTELLIGENT TESTER) |
Clear the DTCs.
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Turn the tester on.
Clear the DTCs using the intelligent tester.
Select the following menu items: Chassis / ABS/VSC/TRC / DTC / Clear.
| DTC CHECK (USING SST CHECK WIRE) |
Check DTCs.
Using SST, connect terminals TC and CG of the DLC3.

- SST
- 09843-18040
Turn the ignition switch on (IG).
Read 2-digit DTCs indicated by the blinking of the ABS and VSC warning lights on the combination meter.
- HINT:
- As an example, the blinking patterns of the normal system code and DTCs 11 and 21 are shown below.


- DTCs are explained in "DIAGNOSTIC TROUBLE CODE CHART" (Click here).
- As an example, the blinking patterns of the normal system code and DTCs 11 and 21 are shown below.
After completing the check, disconnect the SST from terminals TC and CG of the DLC3, and turn the ignition switch off.
- HINT:
- If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.
| CLEAR DTC (USING SST CHECK WIRE) |
Clear the DTCs.
Using SST, connect terminals TC and CG of the DLC3.

- SST
- 09843-18040
Turn the ignition switch on (IG).
Clear the DTCs stored in the skid control ECU by depressing the brake pedal 8 times or more within 5 seconds.

Check that the ABS and VSC warning lights come on.
Remove the SST from the terminals of the DLC3.
Turn the ignition switch off.
- HINT:
- Clearing the DTCs cannot be performed by removing the battery cable or ECU-IG fuse.
| END OF DTC CHECK/CLEAR |
Turn the ignition switch on (IG).
Check that the ABS and VSC warning lights go off within approximately 3 seconds.
Turn the ignition switch off.