2005-2008 Yaris · Service Manual BRAKE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Nov 2005


DTC CHECK (for Using a Intelligent Tester)

  1. Check DTCs.

    1. A107926E08
      Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the tester on.

    4. Read the DTCs using the intelligent tester.
      Select the following menu items: Chassis / ABS/VSC/TRC/ DTC.


DTC CLEAR (for Using a Intelligent Tester)
  1. Clear the DTCs.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the tester on.

    4. Clear the DTCs using the intelligent tester.
      Select the following menu items: Chassis / ABS/VSC/TRC / DTC / Clear.


DTC CHECK (for Using a SST Check Wire)

  1. Check DTCs.

    1. F100115E02
      Using SST, connect terminals TC and CG of the DLC3.
      SST
      09843-18040  

    2. Turn the ignition switch on (IG).

    3. Read 2-digit DTCs indicated by the blinking of the ABS warning light on the combination meter.

      HINT:

      1. As an example, the blinking patterns of the normal system code and DTCs 11 and 21 are shown below.

        F100113E02
      2. DTCs are explained in "DIAGNOSTIC TROUBLE CODE CHART" (Click here).

    4. After completing the check, disconnect the SST from terminals TC and CG of the DLC3, and turn the ignition switch off.

      HINT:
      If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.


CLEAR DTC (for Using a SST Check Wire)

  1. Clear the DTCs.

    1. F100115E02
      Using SST, connect terminals TC and CG of the DLC3.
      SST
      09843-18040  

    2. Turn the ignition switch on (IG).

    3. BR03890
      Clear the DTCs stored in the skid control ECU by depressing the brake pedal 8 times or more within 5 seconds.

    4. Check that the ABS warning light comes on.

    5. Remove the SST from the terminals of the DLC3.

    6. Turn the ignition switch off.

      HINT:
      Clearing the DTCs cannot be performed by removing the battery cable or ECU-IG fuse.


END OF DTC CHECK/CLEAR
  1. Turn the ignition switch on (IG).

  2. Check that the ABS warning light goes off within approximately 3 seconds.

  3. Turn the ignition switch off.

← DIAGNOSIS SYSTEM (from Nov 2005)FREEZE FRAME DATA (from Nov 2005) →