2005-2008 Yaris · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jan 2006


1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG

2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

3. INSTALL PISTON SEAL
  1. Apply lithium soap base glycol grease to a new piston seal.

  1. Install the piston seal onto the disc brake cylinder.

    NOTICE:
    Securely install the piston seal into the groove of the disc brake cylinder.


4. INSTALL FRONT DISC BRAKE PISTON

C116964E02
  1. Apply lithium soap base glycol grease to the piston and a new cylinder boot.

  1. Install the cylinder boot onto the piston.

  1. Install the piston into the disc brake cylinder.

    NOTICE:
    Do not forcibly install the piston into the disc brake cylinder.


5. INSTALL CYLINDER BOOT

C108937E01
  1. Install the cylinder boot into the disc brake cylinder.

    NOTICE:
    Securely install the cylinder boot into the groove of the disc brake cylinder.

  1. Using a screwdriver, install a new set ring.

    NOTICE:
    Do not damage the cylinder boot.

← INSPECTION (from Jan 2006)INSTALLATION (from Jan 2006) →