2005-2008 Yaris · Service Manual BRAKE

C0226/21 SFR Solenoid Circuit

Diagnostic trouble codes · Vehicles built from Aug 2005

Also covers:

DESCRIPTION

This solenoid is turned on in accordance with signals from the skid control ECU and controls the pressure on the wheel cylinders to control the braking force.
DTC No.
DTC Detecting Condition
Trouble Area
C0226/21
C0236/22
C0246/23
C0256/24
Open or short in solenoid circuit continues for 0.05 seconds or more.
Brake actuator

HINT:
C0226/21, C0236/22, C0246/23, C0256/24:
The skid control ECU begins to detect these DTCs when the vehicle speed exceeds 6 km/h (4 mph).


WIRING DIAGRAM

C117850E02

INSPECTION PROCEDURE


1. RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Start the engine.

  1. Drive the vehicle at 6 km/h (4 mph) or more to activate initial check.

  1. Check if the same DTC(s) is output (Click here).

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B

    HINT:
    The DTCs may be stored due to a malfunction in the connector terminal.



B
END
A

REPLACE BRAKE ACTUATOR


← C0210/33 Right Rear Wheel Speed Sensor Signal (+ 7 more codes) (from Aug 2005)C0273/13 Open or Short Circuit in ABS Motor Relay Circuit (+ C0274/14) (from Aug 2005) →