C0273/13 Open or Short Circuit in ABS Motor Relay Circuit
Diagnostic trouble codes · Vehicles built from Aug 2005
Also covers:
- C0274/14 Short to B+ in ABS Motor Relay Circuit
DESCRIPTION
The ABS motor relay supplies the power to the ABS pump motor. While the ABS is activated, the skid control ECU switches the motor relay ON and operates the ABS pump motor.| DTC No. |
DTC Detecting Conditions |
Trouble Areas |
| C0273/13 |
When either of following conditions (1 or 2) detected:
|
|
| C0274/14 |
When motor relay off, motor relay remains closed for 4 seconds or more. |
|
- HINT:
- C0273/13 and C0274/14: The skid control ECU begins to detect these DTCs when the vehicle speed exceeds 6 km/h (4 mph).
WIRING DIAGRAM
Click here.INSPECTION PROCEDURE
| 1. INSPECT FUSE (ABS1/VSC1) |
Remove the ABS1/VSC1 fuse from the engine room R/B.

Measure the resistance.
- Standard Resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (BATTERY - SKID CONTROL ECU - BODY GROUND) |
Confirm that there are no defects in the skid control ECU connector fitting.
Disconnect the skid control ECU connector.
Inspect both the connector case and the terminal for deformation and corrosion.
- OK:
- No deformation or corrosion.
Measure the voltage.

- Standard Voltage:
Tester Connection
Specified Condition
A15-23 (+BM) - Body ground
11 to 14 V
Measure the resistance.
- Standard Resistance:
Tester Connection
Specified Condition
A15-2 (GND1) - Body ground
Below 1 Ω
A15-24 (GND2) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. PERFORM ACTIVE TEST BY INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Perform the active test using the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Active Test.
ACTIVE TEST: ABS Item (Display)
Vehicle Condition / Test Details
Diagnostic Note
Motor Relay
Turns ABS motor relay ON / OFF
Operating sound of motor can be heard
Check the operation sound of the ABS motor when operating it with the intelligent tester.
- OK:
- The operation sound of the ABS motor can be heard.
|
|
||||
| OK | |
| 4. RECONFIRM DTC |
Clear the DTC(s) (Click here).
Start the engine.
Drive the vehicle at 6 km/h (4 mph) or more to activate the initial check.
Check if the same DTC(s) is output (Click here).
Result
Proceed to
DTC output
A
DTC not output
B
|
|
||||
| A | ||
| ||
