C1241/41 Low Battery Positive Voltage or Abnormally High Battery Positive Voltage
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
When there is an abnormality in the power supply circuit of the brake actuator (skid control ECU), the skid control ECU sets a DTC and the operation is prohibited by the fail-safe function. This DTC is set when the voltage supplied to terminal IG1 is outside the DTC detection threshold, due to abnormalities of the battery, power source circuits or charging circuits such as the alternator circuit.The fail-safe function is canceled when the voltage to terminal IG1 returns to normal.
| DTC No. |
DTC Detecting Conditions |
Trouble Areas |
| C1241/41 |
When any of following conditions detected:
|
|
WIRING DIAGRAM




INSPECTION PROCEDURE
| 1. CHECK SKID CONTROL ECU TERMINAL VOLTAGE |
Disconnect the skid control ECU connector.
Turn the ignition switch on (IG).
Measure the voltage.

- Standard Voltage:
Tester Connection
Specified Condition
A15-25 (IG1) - Body ground
11 to 14 V
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTC (Click here).
Drive the vehicle at 3 km/h (2 mph) or more for several seconds.
Check if the same DTC is output (Click here).
Result
Proceed to
DTC output
A
DTC not output
B
|
|
||||
| A | ||
| ||
| 3. INSPECT FUSES (ECU-IG, AM1) |
Remove the ECU-IG and AM1 fuses from the main body ECU.

Measure the resistance.
- Standard Resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 4. INSPECT BATTERY |
Check the battery voltage.
- Standard Voltage:
- 11 to 14 V
|
|
||||
| OK | |
| 5. INSPECT IGNITION RELAY NO. 1 |
Remove the IG1 relay from the main body ECU.

Measure the resistance.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
Always
10 kΩ or higher
3 - 5
Apply B+ between terminals 1 and 2
Below 1 Ω
|
|
||||
| OK | |
| 6. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND) |
Inspect the skid control ECU connector fitting for defects.
Disconnect the skid control ECU connector.
Inspect both the connector case and the terminal for deformation and corrosion.
- OK:
- No deformation or corrosion.
Measure the resistance.

- Standard Resistance:
Tester Connection
Specified Condition
A15-2 (GND1) - Body ground
Below 1 Ω
A15-24 (GND2) - Body ground
Below 1 Ω
|
|
||||
| OK | ||
| ||
