C0278/11 Open or Short Circuit in ABS Solenoid Relay Circuit
Diagnostic trouble codes · Vehicles built from Aug 2005
Also covers:
- C0279/12 Short to B+ in ABS Solenoid Relay Circuit
DESCRIPTION
The solenoid relay supplies power to the ABS solenoid.After the ignition switch is turned on, the vehicle speed has reached 6 km/h (4 mph) and the solenoid is determined to be normal by the initial check self-diagnosis, the relay switches on. If any open or short circuits are detected, the relay switches off.
These DTCs may be set if the voltage supply to the solenoid relay (+BS) falls below the DTC detection threshold due to the battery or alternator outputs being insufficient.
| DTC No. |
DTC Detecting Conditions |
Trouble Areas |
| C0278/11 |
When either of following conditions (1 or 2) detected:
|
|
| C0279/12 |
Immediately after ignition switch turned on, solenoid relay contact closed for 0.2 seconds or more when relay off. |
|
- HINT:
- C0278/11 and C0279/12: The skid control ECU begins to detect these DTCs when the vehicle speed exceeds 6 km/h (4 mph).
WIRING DIAGRAM
Click here.INSPECTION PROCEDURE
| 1. INSPECT FUSE (ABS2/VSC2) |
Remove the ABS2/VSC2 fuse from the engine room R/B.

Measure the resistance.
- Standard Resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (BATTERY - SKID CONTROL ECU - BODY GROUND) |
Inspect the skid control ECU connector fitting for any defects.
Disconnect the skid control ECU connector.
Inspect both the connector case and the terminal for deformation and corrosion.
- OK:
- No deformation or corrosion.
Measure the voltage.

- Standard Voltage:
Tester Connection
Specified Condition
A15-1 (+BS) - Body ground
11 to 14 V
Measure the resistance.
- Standard Resistance:
Tester Connection
Specified Condition
A15-2 (GND1) - Body ground
Below 1 Ω
A15-24 (GND2) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
Clear the DTC(s) (Click here).
Start the engine.
Drive the vehicle at 6 km/h (4 mph) or more to activate the initial check.
Check if the same DTC(s) is output (Click here).
Result
Proceed to
DTC output
A
DTC not output
B
|
|
||||
| A | ||
| ||
