ABS Warning Light Remains ON
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
If any of the following conditions are detected, the ABS warning light remains on:- The ECU connectors are disconnected from the skid control ECU.
- There is a malfunction in the skid control ECU internal circuit.
- There is an open or short in the wire harness between the combination meter and the skid control ECU.
- HINT:
- The intelligent tester may not be used when there is a malfunction in the skid control ECU.
WIRING DIAGRAM




INSPECTION PROCEDURE
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if the CAN communication system DTC is output (Click here).
- Result:
Result
Proceed to
DTC not output
A
DTC output
B
|
|
||||
| A | |
| 2. CHECK CONNECTOR CONNECTION CONDITION |
Check the skid control ECU connector condition.
- OK:
- The connector is securely connected.
|
|
||||
| OK | |
| 3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS WARNING LIGHT) |
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Turn the tester on.
Select the "ABS Warning Lamp" in the ACTIVE TEST and operate the ABS warning light using the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Active Test.
ACTIVE TEST: ABS/VSC/TRC Item (Display)
Test Details
Diagnostic Notes
ABS Warning Lamp
Turns ABS warning light ON and OFF
Observe combination meter
Check that the ABS warning light turns on and off in the combination meter using the intelligent tester.
- OK:
- The ABS warning light turns ON and OFF in accordance with the intelligent tester operation.
- HINT:
- When the ABS warning light remains illuminated, opens in the wire harness of the combination meters or abnormalities in the meter circuit should be considered.
|
|
||||
| OK | ||
| ||
