2005-2008 Yaris · Service Manual BRAKE

TS and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

In sensor check mode, malfunctions of the speed sensor that cannot be detected when the vehicle is stopped can be detected by driving the vehicle.
Transition to sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to on (IG).

WIRING DIAGRAM

C118698E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DLC3 - POWER STEERING ECU)
  1. Turn the ignition switch off.

  1. Disconnect the power steering ECU connector.

  1. C120359E01
    Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D15-12 (TS) - D31-11 (TS)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

  1. F100115E26
    Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D15-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)
  1. Disconnect the power steering ECU connector.

  1. C118701E01
    Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    D31-11 (TS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. REPLACE POWER STEERING ECU
  1. Replace the power steering ECU.

  1. Check for DTCs of the power steering ECU (Click here).

    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A

END


← TC and CG Terminal Circuit (from Aug 2005)PRECAUTION (from Nov 2005) →