DTC CHECK / CLEAR
Troubleshooting · Vehicles built Aug 2005 – Dec 2005
Versions by build date: Aug 2005 – Dec 2005 from Jan 2006
| CHECK DTC |
When using an intelligent tester;

Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Read the DTCs by following the prompts on the intelligent tester.
- HINT:
- Refer to the intelligent tester operator's manual for further details.
When not using an intelligent tester;

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
- SST
- 09843-18040
Turn the ignition switch on (IG).
Read and write down any DTCs indicated by the P/S warning light on the combination meter. Refer to the chart on the left for examples of a normal code and DTCs 21 and 22.

- HINT:
- If the P/S warning light does not blink to display any DTCs set or the normal code, inspect the circuit shown in the table below.
Trouble Area
See Page
EPS warning light circuit
Click here
- If two or more malfunctions are detected simultaneously, DTCs will be displayed in ascending numerical order.
- If the P/S warning light does not blink to display any DTCs set or the normal code, inspect the circuit shown in the table below.
Refer to the Diagnostic Trouble Code Chart (Click here ) for DTC information.
| CLEAR DTC |
When using an intelligent tester;
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Clear the DTCs by following the prompts on the intelligent tester.
Turn the ignition switch off.
Disconnect the intelligent tester from the DLC3.
When not using an intelligent tester;

Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.
- SST
- 09843-18040
Turn the ignition switch on (IG).
Disconnect the SST check wire from terminal 4 (CG) and reconnect it, and repeat this procedure 4 times or more within 8 seconds.
Check that the P/S warning light blinks a code to indicate normality.
Turn the ignition switch off.
Remove the SST from the DLC3.