REMOVAL
Removal / installation · Vehicles built from Jan 2006
| 2.
DRAIN BRAKE FLUID |
 |
- NOTICE:
- Immediately wash off any brake fluid that comes into contact with any painted surfaces.
| 3.
DISCONNECT FRONT FLEXIBLE HOSE |
 |
Remove the union bolt and gasket and separate the flexible hose from the disc brake cylinder.
| 4.
REMOVE DISC BRAKE CYLINDER ASSEMBLY |
 |
Fix the slide pin with a spanner, remove the 2 bolts and remove the disc brake cylinder.
| 5.
REMOVE FRONT DISC BRAKE PAD KIT (PAD ONLY) |
 |
Remove the 2 disc brake pads from the disc brake cylinder mounting.
| 6.
REMOVE FRONT ANTI SQUEAL SHIM KIT |
 |
Remove the No. 1 anti squeal shim and No. 2 anti squeal shim from each brake pad.
| 7.
REMOVE PAD WEAR INDICATOR NO. 1 PLATE |
 |
Remove the indicator plate from each brake pad.
| 8.
REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE |
 |
Remove the 4 disc brake pad support plates from the disc brake cylinder mounting.
| 9.
REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN |
 |
Remove the slide pin (upper) and slide pin (lower) from the disc brake cylinder mounting.
| 10.
REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH |
 |
Using a screwdriver with its tip wrapped in protective tape, remove the slide bush from the slide pin (lower).
| 11.
REMOVE NO. 1 BUSH DUST BOOT |
 |
Remove the 2 dust boots from the disc brake cylinder mounting.
| 12.
REMOVE FRONT DISC BRAKE CYLINDER MOUNTING |
 |
Remove the 2 bolts and remove the disc brake cylinder mounting from the steering knuckle.
| 13.
REMOVE FRONT DISC |
 |
Place matchmarks on the disc and axle hub and remove the disc.