Symbols (Terminal No.)
|
Wiring Colors
|
Terminal Descriptions
|
Conditions
|
Specified Conditions
|
BATT (A21-20) - E1 (C20-104)
|
Y - W
|
Battery (for measuring battery voltage and for ECM memory)
|
Always
|
9 to 14 V
|
+B (A21-2) - E1 (C20-104)
|
B - W
|
Power source of ECM
|
Ignition switch on (IG)
|
9 to 14 V
|
+BM (A21-3) - ME01 (C20-43)
|
GR - BR
|
Power source of throttle actuator
|
Always
|
9 to 14 V
|
IGT1 (C20-85) - E1 (C20-104)
|
W - W
|
Ignition coil with igniter (ignition signal)
|
Idling
|
Pulse generation (see waveform 1)
|
IGT2 (C20-84) - E1 (C20-104)
|
O - W
|
IGT3 (C20-83) - E1 (C20-104)
|
G - W
|
IGT4 (C20-82) - E1 (C20-104)
|
LG - W
|
IGF1 (C20-81) - E1 (C20-104)
|
Y - W
|
Ignition coil with igniter (ignition confirmation signal)
|
Ignition switch on (IG)
|
4.0 to 5.5 V
|
Idling
|
Pulse generation (see waveform 1)
|
NE+ (C20-122) - NE- (C20-121)
|
L - P
|
Crankshaft position sensor
|
Idling
|
Pulse generation (see waveform 2)
|
G2+ (C20-99) - NE- (C20-121)
|
B - P
|
Camshaft position sensor
|
Idling
|
Pulse generation (see waveform 2)
|
#10 (C20-108) - E01 (C20-45)
|
SB - BR
|
Injector
|
Ignition switch on (IG)
|
9 to 14 V
|
#20 (C20-107) - E01 (C20-45)
|
GR - BR
|
#30 (C20-106) - E01 (C20-45)
|
P - BR
|
#40 (C20-105) - E01 (C20-45)
|
L - BR
|
HT1A (C20-109) - E03 (C20-86)
|
G - W
|
Heated oxygen sensor heater (sensor 1)
|
Ignition switch on (IG)
|
9 to 14 V
|
OX1A (C20-112) - EX1A (C20-90)
|
W - L
|
Heated oxygen sensor (sensor 1)
|
Maintain engine speed at 2,500 rpm for 2 minutes after warming up sensor
|
Pulse generation (see waveform 3)
|
HT1B (C20-47) - E03 (C20-86)
|
LG - W
|
Heated oxygen sensor heater (sensor 2)
|
Ignition switch on (IG)
|
9 to 14 V
|
OX1B (C20-64) - EX1B (C20-87)
|
G - GR
|
Heated oxygen sensor (sensor 2)
|
Maintain engine speed at 2,500 rpm for 2 minutes after warming up sensor
|
Pulse generation (see waveform 4)
|
KNK1 (C20-110) - EKNK (C20-111)
|
R - G
|
Knock sensor
|
Engine speed maintained at 4,000 after warming up engine
|
Pulse generation (see waveform 5)
|
SPD (A21-8) - E1 (C20-104)
|
V - W
|
Speed signal from combination meter
|
Driving at 20 km/h (12 mph)
|
Pulse generation (see waveform 6)
|
THW (C20-97) - ETHW (C20-96)
|
L - P
|
Engine coolant temperature sensor
|
Idling, Engine coolant temperature 80°C (176°F)
|
0.2 to 1.0 V
|
ACCR (A21-13) - E01 (C20-45)
|
G - W
|
ACC (Accessory) relay control signal
|
Cranking
|
Below 1.5 V
|
THA (C20-65) - ETHA (C20-88)
|
P - O
|
Intake air temperature sensor
|
Idling, Intake air temperature 20°C (68°F)
|
0.5 to 3.4 V
|
VG (C20-118) - E2G (C20-116)
|
GR - LG
|
Mass air flow meter
|
Idling, Shift lever position N, A/C switch OFF
|
0.5 to 3.0 V
|
W (A21-24) - E1 (C20-104)
|
B - W
|
MIL
|
Ignition switch on (IG)
|
Below 2.5 V
|
Idling
|
9 to 14 V
|
STA (A21-48) - E1 (C20-104)
|
BR - W
|
Starter signal
|
Cranking
|
6.0 V or more
|
VTA1 (C20-115) - ETA (C20-91)
|
Y - V
|
Throttle position sensor (for engine control)
|
Ignition switch on (IG), Throttle valve fully closed
|
0.5 to 1.1 V
|
Ignition switch on (IG), Throttle valve fully open
|
3.3 to 4.9 V
|
VTA2 (C20-114) - ETA (C20-91)
|
GR - V
|
Throttle position sensor (for sensor malfunction detection)
|
Ignition switch on (IG), Throttle valve fully closed
|
2.1 to 3.1 V
|
Ignition switch on (IG), Throttle valve fully open
|
4.6 to 5.5 V
|
VCTA (C20-67) - ETA (C20-91)
|
W - V
|
Power source of sensor (specific voltage)
|
Ignition switch on (IG)
|
4.5 to 5.5 V
|
VCPA (A21-57) - EPA (A21-59)
|
B - G
|
Power source of accelerator pedal position sensor (for VPA)
|
Ignition switch on (IG)
|
4.5 to 5.5 V
|
VPA (A21-55) - EPA (A21-59)
|
R - G
|
Accelerator pedal position sensor (for engine control)
|
Ignition switch on (IG), Accelerator pedal released
|
0.5 to 1.1 V
|
Ignition switch on (IG), Accelerator pedal fully depressed
|
2.6 to 4.5 V
|
VPA2 (A21-56) - EPA2 (A21-60)
|
L - BR
|
Accelerator pedal position sensor (for sensor malfunctioning detection)
|
Ignition switch on (IG), Accelerator pedal released
|
1.2 to 2.0 V
|
Ignition switch on (IG), Accelerator pedal fully depressed
|
3.4 to 5.0 V
|
VCP2 (A21-58) - EPA2 (A21-60)
|
W - BR
|
Power source of accelerator pedal position sensor (for VPA2)
|
Ignition switch on (IG)
|
4.5 to 5.5 V
|
M+ (C20-42) - ME01 (C20-43)
|
G - BR
|
Throttle actuator
|
Idling with warm engine
|
Pulse generation (see waveform 7)
|
M- (C20-41) - ME01 (C20-43)
|
R - BR
|
Throttle actuator
|
Idling with warm engine
|
Pulse generation (see waveform 8)
|
STP (A21-36) - E1 (C20-104)
|
G - W
|
Stop light switch
|
Brake pedal depressed
|
7.5 to 14 V
|
Brake pedal released
|
Below 1.5 V
|
ST1- (A21-35) - E1 (C20-104)
|
Y - W
|
Stop light switch (opposite to STP terminal)
|
Ignition switch on (IG), Brake pedal depressed
|
Below 1.5 V
|
Ignition switch on (IG), Brake pedal released
|
7.5 to 14 V
|
PRG (C20-49) - E01 (C20-45)
|
L - W
|
VSV for EVAP
|
Ignition switch on (IG)
|
9 to 14 V
|
Idling
|
Pulse generation (see waveform 9)
|
FC (A21-7) - E01 (C20-45)
|
V - W
|
Fuel pump control
|
Ignition switch on (IG)
|
9 to 14 V
|
Idling
|
Below 1.5 V
|
TACH (A21-15) - E1 (C20-104)
|
LG - W
|
Engine speed
|
Idling
|
Pulse generation (see waveform 10)
|
TC (A21-27) - E1 (C20-104)
|
P - W
|
Terminal TC of DLC 3
|
Ignition switch on (IG)
|
9 to 14 V
|
OC1+ (C20-100) - OC1- (C20-123)
|
BR - R
|
Camshaft timing oil control valve (OCV)
|
Idling
|
Pulse generation (see waveform 11)
|
CANH (A21-41) - E1 (C20-104)
|
L - W
|
CAN communication line
|
Ignition switch on (IG)
|
Pulse generation (see waveform 12)
|
CANL (A21-49) - E1 (C20-104)
|
W - W
|
CAN communication line
|
Ignition switch on (IG)
|
Pulse generation (see waveform 13)
|
* CAN+ (A21-5) - E1 (C20-104)
|
W - W
|
Communication signal with transmission control ECU
|
Ignition switch on (IG)
|
Pulse generation (see waveform 12)
|
* CAN- (A21-4) - E1 (C20-104)
|
Pulse generation (see waveform 13)
|
* NEO (A21-39) - E1 (C20-104)
|
L - W
|
Engine speed signal
|
Idling
|
Pulse generation (see waveform 14)
|
ELS (A21-31) - E1 (C20-104)
|
G - W
|
Electric load
|
Tail light switch on
|
7.5 to 14 V
|
Tail light switch off
|
Below 1.5 V
|
ELS3 (A21-33) - E1 (C20-104)
|
V - W
|
Electric load
|
Defogger switch on
|
7.5 to 14 V
|
Defogger switch off
|
Below 1.5 V
|
FAN (A21-21) - E1 (C20-104)
|
O - W
|
Fan No. 1 relay
|
Ignition switch on (IG)
|
9 to 14 V
|
Idling with A/C ON or High engine coolant temperature
|
Below 1.5 V
|
FAN2 (A21-22) - E1 (C20-104)
|
LG - W
|
Fan No. 2 relay
|
Idling with high engine coolant temperature
|
Below 1.5 V
|
ALT (C20-50) - E1 (C20-104)
|
P - W
|
Generator
|
Ignition switch on (IG)
|
9 to 14 V
|
IGSW (A21-28) - E1 (C20-104)
|
R - W
|
Ignition switch
|
Ignition switch on (IG)
|
9 to 14 V
|
MREL (A21-44) - E1 (C20-104)
|
GR - W
|
EFI relay
|
Ignition switch on (IG)
|
9 to 14 V
|
STSW (A21-14) - E1 (C20-104)
|
B - W
|
Ignition switch signal
|
Shift lever position N, ignition switch START
|
6.0 V or more
|
STAR (C20-52) - E1 (C20-104)
|
O - W
|
Starter relay control
|
Ignition switch on (IG)
|
Below 1.5 V
|
Cranking
|
6.0 V or more
|