INITIALIZATION
Troubleshooting · Vehicles built from Nov 2005
- NOTICE:
- When the power window regulator motor assembly (on the driver side) is reinstalled or replaced, the power window control system must be initialized. Functions such as the AUTO UP/DOWN, jam protection and key-off do not operate if the initialization is not performed.
- When the initialization cannot be completed successfully, LIN communication problems are a possible cause, therefore the LIN system needs to be inspected.
- After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the AUTO UP function is used, due to detection of the different operation learned value of the door glass movement speed. In such cases, the AUTO UP function can be resumed by repeating the following operation at least 5 times:
- Open the power window by fully pushing down the switch.
- Close the power window by fully pulling up the power window switch and holding it at the AUTO UP position.
- When the power window regulator motor assembly (on the driver side) is reinstalled or replaced, the power window control system must be initialized. Functions such as the AUTO UP/DOWN, jam protection and key-off do not operate if the initialization is not performed.
| INITIALIZE POWER WINDOW CONTROL SYSTEM (POWER WINDOW REGULATOR MOTOR ASSEMBLY (ON DRIVER SIDE)) |
- HINT:
- By resetting the door glass position of the driver door power window (the pulse sensor), the power window regulator motor assembly (on the driver side) is initialized.
- When the power window regulator motor is not replaced with a new one, the initialization is necessary. Prior to performing the initialization, change the mode to pre-initialization mode by disconnecting the connector of the power window regulator motor while the power window is in operation after the power window regulator motor is reinstalled.
- By resetting the door glass position of the driver door power window (the pulse sensor), the power window regulator motor assembly (on the driver side) is initialized.
Connect the battery and turn the ignition switch on (IG).
The indicator of the power window regulator master switch assembly flashes when the initialization preparation is complete.
Fully open the driver door power window by operating the power window regulator master switch (pressing down the driver door power window switch), and continue pressing down for at least 1 second after the window is fully opened.
Fully close the driver door power window by operating the regulator master switch (pulling up the switch), and continue pulling up for at least 1 second after the window is fully closed.
The driver door power window position is reset (the pulse sensor is initialized), and the power window regulator master switch assembly indicator changes from flashing to continuous illumination, to indicate that the initialization has been successfully completed.
- HINT:
- If the indicator does not change to continuous illumination, even when step (d) shown above is finished, repeat the procedure from step (c).