2005-2008 Yaris · Service Manual BODY

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Nov 2005

HINT:
  1. Use these procedures to troubleshoot the power window control system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT

    3.PROBLEM SYMPTOMS TABLE
      ResultĀ 
      Result
      Proceed to
      Fault not listed in problem symptoms table
      A
      Fault listed in problem symptoms table
      B

    B.
    A

    4.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. On-vehicle Inspection (Click here).

    3. Inspection (Click here, Click here and Click here)

    NEXT

    5.ADJUST, REPAIR OR REPLACE
      NEXT

      6.CONFIRMATION TEST
        NEXT

        7.RESET POWER WINDOW MOTOR
        1. If a power window switch AUTO light is blinking, initialize the power window motor (Click here).

        NEXT

        ← SYSTEM DESCRIPTION (from Nov 2005)INITIALIZATION (from Nov 2005) →