2005-2008 Yaris · Service Manual SECURITIES

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Aug 2005


CHECK DTC

  1. A107926E01
    Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the intelligent tester ON.

  3. Select the following menu items: Body / Immobiliser / DTC.

  4. Check DTCs and then write them down.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

  5. Confirm the details of the DTCs. (Click here)


CLEAR DTC (using the intelligent tester)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) (do not start the engine) and turn the intelligent tester ON.

  3. Select the following menu items: Body / Immobiliser / DTC / Clear.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

  4. Erase DTCs by pressing the YES button on the tester.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CLEAR DTC (not using the intelligent tester)
  1. Remove the ECU-B fuse from the engine room R/B for more than 60 seconds, or disconnect the negative battery cable for more than 60 seconds. When disconnecting the negative battery cable, perform the "INITIALIZE" procedure.

← DIAGNOSIS SYSTEM (from Aug 2005)DATA LIST / ACTIVE TEST (from Aug 2005) →