2005-2008 Yaris · Service Manual SECURITIES

DATA LIST / ACTIVE TEST

System information · Vehicles built from Aug 2005


READ DATA LIST

HINT:
Using the intelligent tester Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch on (IG) and turn the tester ON.

  4. Select the following menu items: Body / Engine immobiliser / Data List.

  5. Check the results by referring to the table below.

Certification ECUĀ 
Item
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
IG SW
Ignition switch on (IG) signal / ON or OFF
ON: Ignition switch on (ACC, IG) or start
OFF: Ignition switch off
-
ACC SW
Ignition switch on (ACC) signal / ON or OFF
ON: Ignition switch on (ACC, IG) or start
OFF: Ignition switch off
-
← DTC CHECK / CLEAR (from Aug 2005)DIAGNOSTIC TROUBLE CODE CHART (from Aug 2005) →