2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.

  1. I101550E01
    Remove the caps from the service valves on the refrigerant line.

  1. Connect the Freon collection/recycling device to discharge the refrigerant gas remaining in the refrigeration system.

    NOTICE:
    Use the Freon collection/recycling device in accordance with the manufacturer's instruction manual.


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE ENGINE UNDER COVER RH

4. REMOVE FAN AND GENERATOR V BELT

A107413E01
  1. Loosen bolt A.

  1. Loosen bolt B.

  1. Loosen bolt C.

  1. Release the drive belt tension and remove the fan and generator V belt.


5. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE

I100773
  1. Remove the bolt and disconnect the suction hose.

  1. Remove the O-ring from the suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


6. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

I100774
  1. Remove the bolt and disconnect the discharge hose.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


7. REMOVE COMPRESSOR AND PULLEY

I101587
  1. Disconnect the connector and clamp.

  1. Remove the 4 bolts and compressor.

← ON-VEHICLE INSPECTION (from Aug 2005)INSTALLATION (from Aug 2005) →