2005-2008 Yaris · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jan 2006


1. INSTALL FUEL SENDER GAUGE ASSEMBLY

E107757
  1. Install the fuel sender gauge onto the fuel suction with pump and gauge tube.

  1. A105590
    Connect the fuel sender gauge connector.


2. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

A118738
  1. Install a new fuel suction tube gasket onto the fuel tank.

  1. A118740
    Align the protrusion of the fuel pump with the cutout of the fuel tank and install the fuel suction with pump and gauge tube assembly.

    NOTICE:
    The arm of the sender gauge should not be bent.


3. INSTALL FUEL PUMP GAUGE RETAINER

A119124E01
  1. Using SST, turn the retainer 540° clockwise from the screw starting point and align the claw of the retainer with the matchmark on the fuel tank.

    SST
    09808-14020   (09808-01410, 09808-01420, 09808-01430)

    NOTICE:
    Replace the fuel pump gauge retainer with a new one if not installed properly.
    Part No. 77144-52040

    HINT:
    1. Align the claws of the fuel pump gauge retainer and the tips of SST.
    2. At the point where the retainer is turned 90° from the start of the thread, push the retainer in from the opposite side to the start of the thread. Check that the thread of the retainer is properly engaged with that on the fuel tank.


4. CONNECT CANISTER OUTLET HOSE SUB-ASSEMBLY NO. 1

A115477
  1. Connect the canister outlet hose.


5. CONNECT FUEL EMISSION TUBE NO. 2

A115476
  1. Connect fuel emission tube No.2.


6. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

A125126E01
  1. Insert the fuel tank main tube.

  1. Install the tube joint clip.

    NOTICE:
    1. Check that there are no scratches or foreign matter on the connecting parts.
    2. Check that the fuel tube joint is inserted securely.
    3. Check that the fuel tube joint clip is on the collar of the fuel tube joint.
    4. After installing the tube joint clips, check that the fuel tube joints have not been pulled off.
    5. Do not damage any clips. If a clip is damaged, replace it.


7. INSTALL REAR FLOOR SERVICE HOLE COVER

  1. A119173
    Connect the fuel pump connector.

  1. A118729E01
    Install the rear floor service hole cover with new butyl tape.


8. INSTALL REAR SEAT CUSHION ASSEMBLY

  1. B134923
    Pass the rear seat inner belt through the rear seat cushion slit.

  1. Engage the 3 hooks and install the rear seat cushion cover pad.

    NOTICE:
    Make sure that the 2 rear seat cushion lock hooks and the rear seat cushion frame are securely engaged.


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


10. CHECK FOR FUEL LEAK
  1. When using the intelligent tester.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and the intelligent tester main switch on.

      NOTICE:
      Do not start the engine.

    3. Select the Active Test mode on the intelligent tester.

      HINT:
      Refer to the intelligent tester operator's manual for further details.

  1. Check that there is no fuel leakage anywhere in the fuel system after doing maintenance.

← INSPECTION (from Jan 2006)ON-VEHICLE INSPECTION (from Aug 2005) →