REMOVAL
Removal / installation · Vehicles built from Aug 2005
- NOTICE:
- Always use "Torx" socket wrench E10 when installing the rear seat.
| 1. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY |
Remove the 2 package tray trim suspenders.

Remove the 5 pieces of hook tape.
Disengage the 2 claws and remove the package tray trim.
| 2. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board) |
Release the 2 knobs and remove the deck board.

| 3. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board) |
Remove the spare wheel cover.

| 4. REMOVE DECK FLOOR BOX (w/ Deck Board) |
Release the 2 knobs and remove the deck floor box.

| 5. REMOVE REAR SEAT LEG COVER NO. 1 |
Disengage the 4 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.

| 6. REMOVE REAR SEAT LEG COVER NO. 2 |
Disengage the 3 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.

| 7. REMOVE REAR SEAT ASSEMBLY |
Using "Torx" socket wrench E10, remove the 3 bolts and pull up the rear seat cushion.

Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat.

| 8. REMOVE REAR FLOOR SERVICE HOLE COVER |
![]() ![]() |
Remove the clip from the floor carpet.
Remove the rear floor service hole cover.

Disconnect the fuel pump connector.

| 9. DISCHARGE FUEL SYSTEM PRESSURE |
| 10. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 11. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() ![]() |
Widen the tip of the tube joint clip and pull out the clip.
Pull the fuel tank main tube to disconnect it.
- NOTICE:
- Keep the O-ring free of any foreign matter, as it become contaminated easily.
- Do not use any tools in this procedure.
- Do not forcefully bend or twist the tube.
- Put the tube in a plastic bag to prevent damage and contamination.
- If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
- Do not damage any clip. If a clip is damaged, replace it.
- Keep the O-ring free of any foreign matter, as it become contaminated easily.
| 12. DISCONNECT FUEL EMISSION TUBE NO. 2 |
![]() ![]() |
Loosen the clamp and disconnect fuel emission tube No. 2.
| 13. DISCONNECT CANISTER OUTLET HOSE SUB-ASSEMBLY NO. 1 |
![]() ![]() |
Disconnect the canister outlet hose.
| 14. REMOVE FUEL PUMP GAUGE RETAINER |
![]() ![]() |
Using SST, remove the fuel pump gauge retainer.
- SST
- 09808-14020
(09808-01410, 09808-01420, 09808-01430)
- HINT:
- Align the claws of the fuel pump gauge retainer and the tips of SST.
| 15. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
![]() ![]() |
Remove the fuel suction with pump and gauge tube assembly.
- NOTICE:
- Do not bend the arm of the sender gauge.
Remove the fuel suction tube gasket from the fuel tank.







