Removal / installation · Vehicles built from Aug 2005
1.
REMOVE FUEL SENDER GAUGE ASSEMBLY
Disconnect the connector of the fuel sender gauge.
Release the lock as shown in the illustration and slide the fuel sender gauge to remove it.
2.
REMOVE FUEL PUMP
Disconnect the connector of the fuel pump harness.
Disconnect the fuel pump filter hose.
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, remove the fuel filter and the fuel pump from the fuel sub-tank.
Disengage the 2 claws and remove the fuel suction support.
Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump filter and fuel pump from the fuel filter.
NOTICE:
Do not damage the fuel pump filter.
Do not remove the suction filter.
Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.
Disconnect the fuel pump harness.
Remove the O-ring.
3.
REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, remove the pressure regulator.