2005-2008 Yaris · Service Manual SECURITIES

B278A Short to GND in Immobiliser System Power Source Circuit

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

This DTC is output when the ignition switch power source supply line is open or short.
DTC No.
DTC Detection Condition
Trouble Area
B278A
Ignition switch power source supply line is open or short
  1. Wire harness
  1. Ignition switch
  1. Certification ECU

WIRING DIAGRAM

B108936E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - IGNITION SWITCH)
B108731E04
  1. Disconnect the D55 ignition switch connector.

  1. Disconnect the D60 certification ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D60-30 (VC5) - D55-14 (VC5)
    Below 1 Ω
    D60-40 (AGND) - D55-8 (AGND)
    Below 1 Ω
    D60-30 (VC5) or D55-14 (VC5) - Body ground
    10 kΩ or higher
    D60-40 (AGND) or D55-8 (AGND) - Body ground
    10 kΩ or higher

  1. Reconnect the ignition switch connector.

  1. Reconnect the certification ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK OPERATION OF IGNITION SWITCH
  1. After replacing the ignition switch with a normal one, check that the engine starts.

    OK:
    Engine starts.



NG
REPLACE CERTIFICATION ECU
OK

REPLACE IGNITION SWITCH ASSEMBLY


← B2789 No Response from ID BOX (from Aug 2005)B2790 ID BOX EEPROM Malfunction (from Aug 2005) →