B2789 No Response from ID BOX
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
This DTC is output when the certification ECU does not receive communication signals from the ID code box via LIN for 10 seconds.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2789 |
Certification ECU does not receive communication signals from the ID code box via LIN for 10 seconds. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DTC |
Clear the DTC (Click here).
Recheck for DTC.
Result: Result
Proceed to
B2789 output recurs
A
B2789 output does not recur
B
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX) |


Disconnect the D60 certification ECU connector.
Disconnect the D58 ID code box connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
D60-10 (LIN) - D58-3 (LIN1)
Below 1 Ω
D60-10 (LIN) or D58-3 (LIN1) - Body ground
10 kΩ or higher
Reconnect the certification ECU connector.
Reconnect the ID code box connector.
|
|
||||
| OK | |
| 3. CHECK OPERATION OF CERTIFICATION ECU |
After replacing the certification ECU with a normal one, check for DTC.
Result: Result
Proceed to
B2789 output recurs
A
B2789 output does not recur
B
|
|
||||
| A | ||
| ||
