2005-2008 Yaris · Service Manual STEERING

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL STEERING COLUMN PROTECTOR NO. 1 (for Manual Transaxle RHD)

C107904
  1. Install the steering column protector with the bolt.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }


2. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

C104552E01
  1. Engage the 2 claws to install the ignition (starter) switch assembly onto the steering column bracket assembly upper.


3. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

C136896
  1. Engage the 2 claws to install the un-lock warning switch assembly onto the steering column bracket assembly upper.

    HINT:
    Slide the unlock warning switch assembly, in the direction shown by the arrow in the illustration, to install it.


4. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)
  1. Turn the ignition switch to on (ACC).

  1. C137491E01
    Install the ignition switch lock cylinder assembly into the steering column bracket assembly upper.

  1. Make sure that the ignition switch lock cylinder assembly is securely fixed onto the ignition switch lock cylinder assembly.


5. INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)

  1. C136898
    Remove the key and check that the steering lock function is activated.

  1. C136897
    Insert the key, turn the ignition switch to on (ACC) and check that the steering lock function is inactivated.


6. INSTALL STEERING COLUMN UPPER W/SWITCH BRACKET ASSEMBLY (w/o Entry and Start System)
  1. Fix the steering column assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. C136895
    Install the steering column upper with switch bracket assembly and steering column clamp upper with 2 new steering lock set bolts, and then tighten the bolts until their heads come off.


7. INSTALL TRANSPONDER KEY AMPLIFIER (w/o Entry and Start System)

C103938E01
  1. Engage the 2 claws and install the transponder key amplifier onto the steering column upper with the switch bracket.


8. INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)
  1. Fix the steering column assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. C103937
    Install the steering lock actuator and steering column clamp upper with 2 new steering lock set bolts, and then tighten the bolts until the their heads come off.


9. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY

  1. C057409E01
    Align the matchmarks on steering intermediate shaft assembly No. 2 and the steering sliding yoke and provisionally install them with the bolt.

← DISASSEMBLY (from Nov 2005)INSTALLATION (from Nov 2005) →