REMOVAL
Removal / installation · Vehicles built from Jan 2006
- NOTICE:
- Always use "Torx" socket wrench E10 when removing the rear seat.
- HINT:
- The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim) |
Remove the 2 package tray trim suspenders.

Remove the 5 pieces of hook tape.
Disengage the 2 claws and remove the package tray trim.
| 3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board) |
Release the 2 knobs and remove the deck board.

| 4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board) |
Remove the spare wheel cover.

| 5. REMOVE DECK FLOOR BOX (w/ Deck Board) |
for RH Side:
Remove the deck floor box (Click here).
for LH Side:
Remove the deck floor box.
- HINT:
- Use the same procedure as for the RH side.
| 6. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board) |
Remove the rear floor carpet.

| 7. REMOVE REAR SEAT LEG COVER |
for RH Side:
Remove the rear seat leg cover (Click here ).
for LH Side:
Remove the rear seat leg cover (Click here ).
| 8. REMOVE REAR SEAT ASSEMBLY |
for RH side:
Remove the rear seat assembly (Click here ).
for LH Side:
Remove the rear seat assembly (Click here ).
| 9. REMOVE FRONT DOOR SCUFF PLATE |
Disengage the 8 claws and remove the front door scuff plate.

| 10. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP |
Remove the front door opening trim weatherstrip to the extent that the front quarter trim panel can be removed.

| 11. REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY |
Remove the 2 bolts and the front seat outer belt bar.

| 12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY |
Remove the belt of the rear seat outer belt from the rear seat shoulder belt hanger.

Disengage the 8 clips, the retainer and the 10 claws and remove the front quarter trim panel.

| 13. REMOVE REAR SPEAKER ASSEMBLY |
Disconnect the connector.

Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the rear speaker assembly from the quarter panel.
Operate the drill around the rivet head circumference and cut out the flange.
- CAUTION:
- Be careful. The cut rivet is very hot.
- NOTICE:
- Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.
After drilling out the flange, continue drilling to push out the shards on the drill.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the quarter panel.
