2005-2008 Yaris · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jan 2006

NOTICE:
Always use "Torx" socket wrench E10 when installing the rear seat.

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. INSTALL REAR SPEAKER ASSEMBLY

  1. B138653
    Engage the 2 claws of the speaker with the body and provisionally install the speaker.

  1. B138654E01
    Using an air riveter or hand riveter, install the front No. 1 speaker assembly onto the front door panel with 3 new strike rivets.

    HINT:
    Install the new strike rivets in the order shown in the illustration.

    NOTICE:

    1. B130465
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. B130466
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet onto the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. B130467
      Do not leave any space between the speaker and door. Firmly hold the 2 items together while installing the rivet.

  1. B138655
    Connect the connector.


2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY

  1. B114499
    Engage the 8 clips, the retainer and the 10 claws and install the front quarter trim panel.

  1. B114498
    Install the belt of the rear seat outer belt onto the rear seat shoulder belt hanger.


3. INSTALL FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY

  1. B114759
    Install the front seat outer belt bar with the 2 bolts.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }


4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

  1. B114477
    Install the front door opening trim weatherstrip.


5. INSTALL FRONT DOOR SCUFF PLATE

  1. B114494
    Engage the 8 claws and install the front door scuff plate.


6. INSTALL REAR SEAT ASSEMBLY
  1. for RH Side:

    1. Install the rear seat assembly (Click here ).

  1. for LH Side:

    1. Install the rear seat assembly (Click here ).


7. INSTALL REAR SEAT LEG COVER
  1. for RH Side:

    1. Install the rear seat leg cover (Click here ).

  1. for LH Side:

    1. Install the rear seat leg cover (Click here ).


8. INSTALL DECK FLOOR BOX (w/ Deck Board)
  1. for RH Side:

    1. Install the deck floor box (Click here).

  1. for LH Side:

    1. Install the deck floor box.

      HINT:
      Use the same procedure as for the RH side.


9. INSTALL SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)

  1. B138393
    Install the spare wheel cover.


10. INSTALL DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  1. B106447
    Set the deck board and lock the 2 knobs.


11. INSTALL REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

  1. B138392
    Install the rear floor carpet.


12. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

  1. B114569E01
    Engage the 2 claws and install the package tray trim panel.

  1. Install the 5 pieces of hook tape.

  1. Install the 2 package tray trim suspenders.


13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REMOVAL (from Jan 2006)PRECAUTION (from Aug 2005) →