2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Nov 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE STEERING PAD (w/o Steering Pad Switch)

C128889E01
  1. Insert a screwdriver 20cm into the hole in the back side of the steering wheel and raise the spring slightly until its release is felt and disengage the lower claw.

  1. C136892
    Push out the steering pad in the direction shown in the illustration and disengage the 2 claws.

  1. C128890E01
    Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn terminal.


3. REMOVE STEERING PAD (w/ Steering Pad Switch)

C128888E01
  1. Insert a screwdriver 20cm into the hole in the back side of the steering wheel and raise the spring slightly until its release is felt and disengage the lower claw.

  1. C136891
    Push out the steering pad in the direction shown in the illustration and disengage the 2 claws.

  1. C128891E01
    Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn terminal.

← ON-VEHICLE INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →