2005-2008 Yaris · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Nov 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).


1. INSTALL STEERING PAD (w/o Steering Pad Switch)

C129955E01

NOTICE:
Do not use a steering pad that has been dropped.

  1. Confirm that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    Do not begin the operation for at least 90 seconds after the negative battery terminal is detached.

  1. Connect the horn terminal.

  1. Connect the airbag connector.

    NOTICE:
    Securely lock the locking button.

  1. C129957
    Make sure that the 2 upper claws are aligned and engage them.

  1. Push down the steering pad and engage the lower claw.

    NOTICE:
    If the blind cover is stuck between the steering pad and the steering wheel, push it back to its original position.


2. INSTALL STEERING PAD (w/ Steering Pad Switch)

C129954E02
  1. Connect the horn terminal.

  1. Connect the airbag connector.

    NOTICE:
    Securely lock the locking button.

  1. C129956
    Make sure that the 2 upper claws are aligned and engage them.

  1. Push down the steering pad and engage the lower claw.

    NOTICE:
    If the blind cover is stuck between the steering pad and the steering wheel, push it back to its original position.


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


4. INSPECT SRS WARNING LIGHT
(Click here)
← REMOVAL (from Nov 2005)DISPOSAL (from Nov 2005) →