Removal / installation · Vehicles built from Jan 2006
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
1.
INSTALL SPIRAL CABLE
Check that the ignition switch is turned to OFF.
Confirm that the negative battery terminal is detached.
CAUTION:
Do not begin the operation for at least 90 seconds after the negative battery terminal is detached.
Confirm that the front tires face straight forward.
Confirm that the turn signal switch is in the neutral position.
NOTICE:
Perform the operation when the turn signal switch is in the neutral position. Otherwise, the pin of the turn signal will break.
Engage the 3 claws and install the spiral cable.
NOTICE:
Pull the lock pin out before installing the steering wheel, when replacing the spiral cable with a new one.
Connect the airbag connector.
Connect the horn connector.
2.
INSTALL STEERING COLUMN COVER
Engage the 2 claws and install the steering column upper cover.
Engage the 2 claws and install the steering column lower cover.
Tighten the 3 screws.
3.
ADJUST SPIRAL CABLE
Center the spiral cable.
Turn the spiral cable counterclockwise until it locks.
HINT:
The spiral cable turns a maximum of approximately 5 times.
Turn the spiral cable 2.5 times clockwise from its locked position and align the center marks.
4.
INSTALL STEERING WHEEL ASSEMBLY
Align the matchmarks and install the steering wheel assembly onto the steering column assembly.
Install the nut.
Torque:
50 N*m{
510 kgf*cm
, 37 ft.*lbf
}
Connect all connectors to the spiral cable.
5.
INSTALL STEERING PAD
Connect the horn connector.
Connect the airbag connector.
NOTICE:
Align the color of the airbag connector with that of the steering pad assembly, and install the airbag connector.
Securely lock the locking button.
Install the steering pad.
Using "Torx" socket wrench T30, tighten the 2 bolts.