INSPECTION
Inspection · Vehicles built from Jan 2006
| INSPECT SPIRAL CABLE |
![]() ![]() |
Check the spiral cable.
Using an ohmmeter, measure the resistance between the terminals.
- SST
- 09082-00030
- Set the spiral cable in the center, and measure the resistance in each position where the spiral cable is turned 2.5 times clockwise and counterclockwise.
- Turn the spiral cable 2.5 times clockwise from its original position and measure the resistance while turning it 5 times counterclockwise.
- Standard resistance:
Tester Connection
Specified Condition
A1(D-) - D2(D-)
Below 1 Ω
A2(D+) - D1(D+)
Below 1 Ω
- NOTICE:
- To avoid breakage of the spiral cable, do not turn the spiral cable more than necessary. If the result is not as specified, replace the spiral cable.


