REMOVAL
Removal / installation · Vehicles built from Jan 2006
- CAUTION:
- Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE STEERING PAD |
![]() ![]() |
Using "Torx" socket wrench T30, loosen the 2 bolts completely.
Pull the steering pad toward you.
Using a thin-bladed screwdriver, release the locking button.

Using a thin-bladed screwdriver, disconnect the 2 airbag connectors.
Detach the horn connector.
| 3. REMOVE STEERING WHEEL ASSEMBLY |
Remove the nut and place matchmarks on the steering wheel assembly and steering column assembly.

Using SST, remove the steering wheel assembly.

- NOTICE:
- Apply a small amount of grease to the threads and tip of the SST center bolt before using.
| 4. REMOVE STEERING COLUMN COVER |
Remove the 3 screws.

Disengage the 2 claws and remove the steering column lower cover.
Disengage the 2 claws and remove the steering column upper cover.

| 5. REMOVE SPIRAL CABLE |
![]() ![]() |
Detach the horn connector.
Slide the slider and detach the airbag connector.
Disengage the 3 claws and remove the spiral cable.



