INSTALLATION
Removal / installation · Vehicles built from Aug 2005
- CAUTION:
- Some of these service operations affect the SRS airbag system. Be sure to read the precautionary notices concerning the SRS airbag system before servicing (Click here).
| 1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY |
![]() ![]() |
Confirm that the ignition switch is turned to off.
Confirm that the negative battery terminal is detached.
- CAUTION:
- Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
- Do not start the operation for at least 90 seconds after disconnecting the negative battery terminal.
- Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
Remove the 3 bolts and remove the airbag sensor.
- Torque:
- 18 N*m{ 180 kgf*cm , 13 ft.*lbf }
- NOTICE:
- Do not use an airbag sensor that has been dropped.
- Do not subject the airbag sensor to any impact or force.
- Confirm that the carpet does not interfere with the installation plane.
- Do not use an airbag sensor that has been dropped.
Confirm that there is no looseness by shaking the front airbag sensor.
Connect the connector holder to lock the lever.

- NOTICE:
- Confirm that the lever is locked.
Confirm that the drip-proof sheet has not been removed and does not cut into the connectors.

| 2. INSTALL CONSOLE BOX ASSEMBLY REAR |
![]() ![]() |
Engage the 2 clips and install the console box with the bolt.
| 3. INSTALL CONSOLE BOX CARPET |
![]() ![]() |
Install the console box carpet.
| 4. INSTALL CONSOLE BOX REAR COVER |
![]() ![]() |
Engage the 8 claws to install the console box rear cover.
| 5. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle) |
![]() ![]() |
Engage the 6 claws to install the shifting hole cover.
| 6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
| 8. INSPECT SRS WARNING LIGHT |





